Changes

<li><p>Then use decompression software to decompress the compressed package of the downloaded Android image. Among the decompressed files, the file ending with &quot;.img&quot; is the Android image file, and the size is more than 1GB</p></li>

<li><p>Then use decompression software to decompress '''SDDiskTool_v1.72.zip''', this software does not need to be installed, just find '''SD_Firmware_Tool.ex''' in the decompressed folder and open it</p></li>

[[File:plus5-img151.png]]

<li>After opening '''SDDiskTool''', if the TF card is recognized normally, the inserted disk device will be displayed in the &quot;'''Select Removable Disk Device'''&quot; column. '''<span style="color:#FF0000">Please make sure that the displayed disk device is consistent with the drive letter of the TF card you want to burn</span>''', if there is no display, you can try to unplug the TF card</li>

<ol start="12" style="list-style-type: decimal;">

<li><p>After the burning is completed, the display is as shown in the figure below, and then you can exit SDDiskTool</p></li>

[[File:plus5-img161.png]]

<li><p>Then pull out the TF card from the computer and insert it into the development board. After the development board is powered on, it will automatically start burning the Android image in the TF card to the eMMC of the development board.</p></li>

<li><p>If the development board is connected to an HDMI display, you can also see the progress bar of burning the Android image to eMMC from the HDMI display</p></li>

[[File:plus5-img162.png]]

<li><p>When the HDMI monitor displays the following information, it means that the burning of the Android image into the eMMC has been completed. At this time, the TF card can be pulled out, and then the Android system in the eMMC will start.</p>

<p>[[File:plus5-img163.png]]</p></li></ol>